Since getting the rubber flooring I want for trailer floor is not happening anytime soon, Figure can paint for now,Only have to unload two butt loads of stuff. Black girl butt loads too.

Thinking rustoleum best bet for good coverage, adhesion and cost.Hell worked great on roof as suggested here by a member. Almost zero steraks to clean off. Plus 60 to 90 bucks vs 800. As I see that, half set of pistons or set of ported rings now needed for them for bigger engine workking on getting parts for.

So anyone painted floor of trailer that has been used as shop too and had good amount of oil and trans fluid on it. Always cleaned ASAP but till hit floor, If so what you use for paint and cleaning. Oh yea T&G wood floor?

Plan is scrub with cleaners like purple stuff or simular, Then sao[ and water. followed by floor sander(hell sitting here) followed by Blown out 4 or 5 times. Then paint Rustoleum. Open to suggestions on paint or better cleaning to make adhere. damn sure warm enough out to dry quick,heat suck.

This message has been edited. Last edited by: wideopen231,