On the grid shift light page. What do I put in the shift light low and shift light high box. I have turned on the test and it fires solenoid when applying power. So on the gear box at bottom I have my rpm set that I want to shift. Havnt tested it yet but will tonight to see if it works. I currently have car strapped down in trailer is why I havnt tested that feature yet. I was just wondering about the shift light low and high boxes. I put 0 in both of them but unsure any help would be greatly appreciated Thanks.

I am pretty sure those are used to target a launch rpm, the light turns on when it sees the "low limit" and starts to blink when you go pass the "high limit". If you are using the shift light to trigger a relay, then both low and high should be set to "0".

Joe

This message has been edited. Last edited by: sr4440, August 26, 2022 04:09 PM

Thanks Joe. Then I should have it right. I appreciate the reply.

You want the Launch Light Low/High both set to a value "greater than" the Maximum REV Limit. 15000 would be a good choice for both.

Thanks. It didn’t shift set at 2000 and shift light low and high on 0.