On the grid shift light page. What do I put in the shift light low and shift light high box. I have turned on the test and it fires solenoid when applying power. So on the gear box at bottom I have my rpm set that I want to shift. Havnt tested it yet but will tonight to see if it works. I currently have car strapped down in trailer is why I havnt tested that feature yet. I was just wondering about the shift light low and high boxes. I put 0 in both of them but unsure any help would be greatly appreciated Thanks.
Jeff McClure
Posts: 241 | Location: Texas | Registered: December 02, 2006
I am pretty sure those are used to target a launch rpm, the light turns on when it sees the "low limit" and starts to blink when you go pass the "high limit". If you are using the shift light to trigger a relay, then both low and high should be set to "0".
JoeThis message has been edited. Last edited by: sr4440,
Without data, you’re just another guy with an opinion.
Posts: 1313 | Location: TEXAS | Registered: February 07, 2003