Hi,
Double checking configurations.

All MSD Grid electronics. Crank trigger.
Powerglide. Very loose converter (6650 RPM).
Yellow wire to Shift input on Digital Delay relay panel.
Objective is to shift @ 7100 RPMs.

Are these correct?










Thank you in advance,
Clark

My work computer won't allow a lot of photo sites to come through, but I looked on my phone and can't make out any of the text in the photos. My eyes are pretty good.

In Shift Light, program both Launch Light High/ Low to 15,000. You are not using it and even if you were it wouldn’t work properly as programmed.

In Gear Shift, program the Shift Delay to 0.00. Program the Launch Delay to 1.00. initially. After making several runs, determine when the shift light activates and re-program Launch Delay to 0.25 less than this amount. Example… Shift Light activates 1.65 after Launch, program Launch Delay to 1.40.

Launch Dely does Not allow the Shift Counter to advance in the event you lift off the pedal prior to the shift activating.

Output Switch is disabled…… Not Using.

Confirm that Shift Light works to shift by programming the Power-On Test to ON and cycling the Ignition ON switch. Should activate the Shift Light output for 3 seconds.

Thank you and will do.

Clark