June 04, 2018, 10:31 AM
TomRMSD grid wiring problems (check your harness)
I purchased and decided to install a grid power module (7764) so I could data log engine temperature on a run.
I was trying to program it but could not get a couple things to work correctly. After rewiring it and tracing my wires many times, I could not get #3 Pink or #4 Yellow to work. I was ready to throw in the towel and rip it all out when I found the following.
MSD, are you kidding me? How could they screw up pinning the harness. At least it only took me a day to find it, lol. Who would have thought they could screw this up?
June 04, 2018, 11:16 AM
MasRacingIt does happen. I had the same issue with a digital 6al on a dirt car I wired. They had mis pinned the tach wire. Easy fix but a pain.
June 04, 2018, 11:29 AM
CURTIS REEDFrom someone who runs a production shop. It was assembled by a human. Humans make mistakes. Sucks but I haven't figured out how to idiot proof everything because they keep making better idiots. LOL Myself included from time to time.
I would expect a circuit QC check before it leaves, but it is possible that it was missed.
Curtis
June 04, 2018, 12:44 PM
TomRBeing on the production side myself, anything is possible. Just figured this wouldn't make it thru quality control. I wonder how many more are like this.
June 04, 2018, 01:12 PM
markemarkI believe those that install MSD products frequently have experienced this type problem. Checking to see that all the pins are properly seated in the plug ends prior to install is wise.
When things don’t work, checking the wire pin out (listed in instructions) and metering between the wires ends can help lead to the cause. Although wires look attached to the pin, they might not be properly connected to have continuity.
June 04, 2018, 01:51 PM
TomRI will definitely check the harnesses/pins going forward.
I posted this to warn others so they don't go thru what I just did.
June 04, 2018, 04:02 PM
jenavetI had the same problem when I got my grid,took me a week to find the pin problem.mark on here was a big help.
but man I spent a lot of wasted time to find an assembly issue