September 25, 2019, 05:37 PM
AlaskaracerAccessing boost retard module in the grid
Markemark, how do I access the data from my boost retard module when accessing the grid? I have the module installed to map crankcase vacuum but I can't remember how to pull up the data when I am looking at my recordings. Any tips/suggestions/help?
Mark Goulette
Owner/Driver of the Livin' The Dream Racing dragster
www.livinthedreamracing.com"Speed kills but it's better than going slow!"
Authorized Amsoil Retailer
September 25, 2019, 06:13 PM
markemarkIn Grid Boost Module (7762/3) go to the Data Acquisition Tab and Enable what you want recorded in Grid Data Accusation.
When attached to Grid chose Data Acquisition on the top line and then select “Recordings” and download.
September 25, 2019, 07:46 PM
AlaskaracerThanks, but the main issue I have is I don't see the module anywhere. I thought once it was plugged in that it would show up and it doesn't. Not sure what I'm doing wrong..
Mark Goulette
Owner/Driver of the Livin' The Dream Racing dragster
www.livinthedreamracing.com"Speed kills but it's better than going slow!"
Authorized Amsoil Retailer
September 25, 2019, 10:08 PM
markemarkOk I understand your problem now.
When connecting to Grid modules through CAN-bus the Ignition Switch to Grid needs to be turned ON. You also might need to allow some extended time (2 min at most) for the computer to establish this connection to the module the first time. You can also toggle the “Refresh” button in the Grid Connection Status box if the module does not show up.
Let me know if this helps.
September 26, 2019, 05:33 AM
AlaskaracerThanks! I'll give that a try!
Mark Goulette
Owner/Driver of the Livin' The Dream Racing dragster
www.livinthedreamracing.com"Speed kills but it's better than going slow!"
Authorized Amsoil Retailer