|
Go | New | Find | Notify | Tools | Reply |
DRR Top Comp |
Those are still the steps. Look for those options. On a phone it's a condensed version. | |||
|
DRR Trophy |
Once I get it the pictures uploaded to IMGUR how do I get them on here | |||
|
DRR Top Comp |
Hover your finger, the share option will show, choose the BBC (forums) option. | |||
|
DRR Trophy |
Well for some reason the BBC forums are not an option. When I get home tonight I will get on my computer and try to figure it out | |||
|
DRR Top Comp |
You'll figure it out. It's breeze once it's done one time. Just takes a minute to figure out. Everyone who's been new at it here , was on the same pace in getting it, as you are. | |||
|
DRR Trophy |
It is very common that the nose block gets trimmed a bit to fit the oil pans. The TS400 starter will give you a little more room but you would likely still have a issue with the noseblock. Meziere Tech. Make sure your water pump is on whenever you check your coolant level. | |||
|
DRR Trophy |
I got the TS500 to work. Set it up in the mill and milled off what I needed to make it work. | |||
|
DRR Trophy |
Here are links to the before, after and installed pictures. Still have not figured out posting the pictures yet https://i.imgur.com/tiKwhbB.jpg https://i.imgur.com/gXiRNot.jpg https://i.imgur.com/WXCGvMN.jpg | |||
|
DRR Top Comp |
Looks good. Nothing wrong with that. | |||
|
DRR Trophy |
Thanks | |||
|
DRR Top Comp |
You'll like the Brodix T1 233. What's the combo? Cam specs, stroke, compression? etc etc? | |||
|
DRR Trophy |
I will get the cam specs when I get home. I do know it is .675 on both sides. 4 inch stroke, 4.185 bore (440 cid) Mahle coated gass ported dome pistons. Heads are the CNC STS with 64cc chambers. Rons Terminator Injection. It is a little over 14 to 1 compression. | |||
|
DRR Trophy |
Nice work, I'll tell you most do not do that nice of a job. Most get the grinder treatment! Meziere Tech. Make sure your water pump is on whenever you check your coolant level. | |||
|
DRR Trophy |
Oh heck no. For what this thing cost no dang grinder was going near it lol. If I would have caught this before I installed the engine I would have pulled the oil pan and modified it. But I came up with a way to do it that worked out pretty nice. But I am also not one to be scared to try stuff either. Sometimes it works and sometimes i have to weld it back together lol | |||
|
Powered by Social Strata | Page 1 2 |
Please Wait. Your request is being processed... |