does anyone have a source for a 1/4 inch ball that has a longer stud trying to mount my throttle return spring tab and run a inline throttle stop and the standard-length stud length is just too short for my liking
if you are not sure what in talking about it is similar to jegs PN 555-15729

Do you need the ball to be further out or the threaded stud longer?

I think you're looking for longer threads but an Edelbrock 8016 MIGHT accomplish what you're trying to do?

This message has been edited. Last edited by: imakehp,

If you need longer threads, here are a couple?

https://proshop.summitracing.com/parts/krc-1042



https://proshop.summitracing.com/parts/sbc-9168k

quote:

Originally posted by 1leg:
https://www.mcmaster.com/products/ball-studs/

Been using them for many...many moons!

2BKING

I just replaced mine. Order it from Jegs part number 555-15734. I have a Biondo stop and a Lokar spring set up