January 12, 2020, 04:38 PM
AlaskaracerATTEN: markemark
Had an issue with the grid I hope you can help with. I tried to download my runs last night and I couldn't find them. It appeared that it didn't save them. The other issue was that I kept getting SD card errors....never done that before....
Any suggestions on what to do, check, or fix?
January 12, 2020, 10:59 PM
markemarkAttach to Grid with laptop. Select the Upper Right Monitor Tab. In the selection list below , choose Free Storage. Unseat the SD card by pushing gently on it, and then re-seat SD card watching the Free Storage display. When seated properly you should see a value of 2.0 or greater.
January 15, 2020, 09:11 PM
AlaskaracerThanks. I'll give it a try
January 18, 2020, 01:13 PM
AlaskaracerOk, we're good there but I just figured out another issue. I have two wideband controllers and one boost retard module. The grid is only seeing one o2 module and not the other or the retard module. I've tried unplugging them and replugging them, Unplugging and replugging in the terminating resistor, and the extension harness and add on module. But no go. Only reads the one o2 module. Suggestions?
January 18, 2020, 03:49 PM
markemarkFirst try this. With a laptop that has an internet connection, open MSDView4. It should go out on the net and look for the latest version and you want to select version 4.4.7 and install both parts.
If it doesn’t find this upgrade go here
https://www.holley.com/support/ignition/ and pick the MSD VIEW Software. It’ll be version 4.4.0 that you will get and install.
Attach to Grid and it should ask if you want to upgrade the firmware to ver 1.8.0 . Agree and then wait for the install to complete and do nothing during this period.
Unplug all modules and plug in only the one that it is not seeing, turn on ignition and wait up to 2 minutes to see if communication is made. If this works, then unplug and plug in the next one not seeing. If it then sees all individually, then plug all of them into hub and see if it now works.
January 18, 2020, 07:43 PM
AlaskaracerThanks Mark, I'll try that all next.
January 18, 2020, 07:57 PM
Alaskaracerwhen you say both parts, do you mean the beta version as well or just the update?
January 18, 2020, 08:00 PM
markemarkNO. Just select the 4.4.7 , NOT beta
All updates install in 2 parts (inclusive) and both need to be installed
January 18, 2020, 08:05 PM
AlaskaracerOk. just finished downloading it. I'll hook it up to the car tomorrow.