Is there anyone other making "beam breaker" for specific cars. : [IMG] [IMG:right][/IMG]This message has been edited. Last edited by: Mr Bill, June 27, 2019 06:48 AM
June 28, 2019, 10:45 AM
Cashflow
Personally I've never heard of anyone. I would think you could make your own with some sheet metal and tubing. Good luck!
Clowns to the left of me, Jokers to the right. Here I am.......
July 01, 2019, 06:04 AM
Mr Bill
I sort I figured I have to make my own Beam Breaker , was mort curious than anything.
July 01, 2019, 10:47 AM
SuperPro54
Sharp 57
July 01, 2019, 11:37 AM
Mr Bill
quote:
Originally posted by SuperPro54: Sharp 57
Thanks, It is bad ass. really hard to tell it has a fiberglass front clip...
July 01, 2019, 12:36 PM
SuperPro54
Whats it weight? Times?
July 01, 2019, 02:25 PM
Mr Bill
quote:
Originally posted by SuperPro54: Whats it weight? Times?
I haven't had it weighted yet, but the guy I bought if from 3400, its getting ready for a big time diet. It was set up for super street. It has all original glass, door, qtrs, and roof. has origianl frame modified for the tubs..
July 05, 2019, 07:09 AM
ski_dwn_it
Built mine with plastic cutting board material from Walmart and ordered some tension hinges that allow it to be flipped up when loading and unloading.
I use it because the nose of the corvette sticks out a good bit from air dam. Cost me a 5k race years ago in finals where in broke out by .003 on the brakes. Fastest run off the day on the brakes... That was an expensive lesson... Utilize it now and car is the same on and off brakes.
3700#+210lb driver, FULL interior, through mufflers, 10.5 tire. 60'-1.333 (IN 4000ft DA! Joisy Math excluded; 1.25sec using JOISY MATH.) 1/4 - 9.60@144MPH
[IMG] [IMG:right]
[/IMG]This message has been edited. Last edited by: Mr Bill, 
