I'm adding a couple of doors into the gooseneck of my race car trailer.
I'm unable to find a supplier of aluminum trim for my project.
I'm looking for some 1" flat on 1 side with beveled edges.
Second is 1/2" angle that is flat on outside with rounded edges for drip rail around door edge.
Any ideas? Google seems to show every thing but hat I'm looking for,

WAG..... Grainger?

Bruce, I am not sure I understand exactly what you are describing to help you look.


One suggestion is McMaster-Carr though.

Looking for the bottom piece with the bevel. Approximately 1 3/8" wide





Angle piece is 7/8 X 5/8

Gotcha.
How thick is the 1 3/8" piece?

I will do some looking. The angle looks to be a special extrusion.

Here is one part.

https://eagle-aluminum.com/pro...inum-cove-1316-x-58/

Same place has 1" that looks nice but not exact, I don't see 1 3/8"

https://eagle-aluminum.com/pro...l-1-x-316-half-oval/

This message has been edited. Last edited by: CURTIS REED,

Wish I could help you out,but I am having a similar problem finding extrusions for building cpl cabinets. You would think with all the stuff everyone can find on the internet it would be easier to find this stuff.

This message has been edited. Last edited by: wideopen231,

quote:

Originally posted by CURTIS REED:
Here is one part.

https://eagle-aluminum.com/pro...inum-cove-1316-x-58/

Same place has 1" that looks nice but not exact, I don't see 1 3/8"

https://eagle-aluminum.com/pro...l-1-x-316-half-oval/

Curtis I found this sight ^^ after I my original post. The beveled part I have found no where. Might have to go with the curved piece.
The beveled piece is approximately 1/8" thick
Thanks again