part number on 12 point 12 degree profilers head studs

Bracket Talk

This topic can be found at:
https://drr.infopop.cc/eve/forums/a/tpc/f/80760912/m/8267033086

March 01, 2018, 10:14 AM

td9757

part number on 12 point 12 degree profilers head studs

part number on 12 point 12 degree profilers head studs. block is merlin tall deck 598 if that matters

March 01, 2018, 11:32 AM

TOP38

Call Profiler or ARP for a kit number.

March 01, 2018, 12:19 PM

Kenneth

Call Reher-Morrison.

March 01, 2018, 08:32 PM

Alaskaracer

quote:
Originally posted by Kenneth:
Call Reher-Morrison.

^^This. ARP doesn't make a stud kit for these heads. The kit from Reher will also have the proper undersize washers to fit in the counter bores for the stud nuts. Regular washers won't fit.

Mark Goulette
Owner/Driver of the Livin' The Dream Racing dragster
www.livinthedreamracing.com
"Speed kills but it's better than going slow!"
Authorized Amsoil Retailer

March 02, 2018, 08:30 AM

TOP38

quote:
Originally posted by Coloradoracer:
quote:
Originally posted by Kenneth:
Call Reher-Morrison.

^^This. ARP doesn't make a stud kit for these heads. The kit from Reher will also have the proper undersize washers to fit in the counter bores for the stud nuts. Regular washers won't fit.

With all the different heads out there that makes sense but it's not rocket science. There are only two holes per head that need a small diameter washer, easy enough to do some customer adjusting.

March 11, 2018, 12:44 PM

td9757

maybe my problem of the engine builder used the wrong washers cause some are tight in the pocket and some studs look like they was modified or cut off

March 11, 2018, 06:10 PM

Will Harrison

quote:
Originally posted by TOP38:
quote:
Originally posted by Coloradoracer:
quote:
Originally posted by Kenneth:
Call Reher-Morrison.

^^This. ARP doesn't make a stud kit for these heads. The kit from Reher will also have the proper undersize washers to fit in the counter bores for the stud nuts. Regular washers won't fit.

With all the different heads out there that makes sense but it's not rocket science. There are only two holes per head that need a small diameter washer, easy enough to do some customer adjusting.

yup, wasn't that big of a deal to cut down 4 washers. Other then the 4 washers the kit from ARP works perfect.