July 02, 2019, 06:17 PM
NHRA1877Fuel access panel
Looking if anyone has any pictures or products of a very clean access panel installed. Specifically on a roadster but looking for something clean. Car is going from a .90 car on gas to a bracket car on alch and taking off 10 dzus fasteners and a hood in late rounds is not convienient.
July 03, 2019, 11:10 AM
TomR http://autofabcart.net/fuelaccessdoor.aspxI ended up using parts of this to install the fuel door on my hood. I cut the fiberglass and reused the portion I cut out. It takes a steady hand or in my case, a lot of filing to get the lines straight again. I used the thinnest cut off wheel I could find for the straight lines and a coping saw blade by hand for the radius corners.
Take your time to measure and prep everything. The more time you take, the better it will look when completed.
July 03, 2019, 01:12 PM
NFC https://www.jerrybickel.com/fu...ce-mount-carbon.htmlI did the same thing as above on my old camaro. Take your time and reuse the chunk you cut out. A rotozip with a small bit works good also. just use the hardware from the kit.