DragRaceResults.Com    Bracket Talk    Bracket Talk Forum  Hop To Forum Categories  Tech Talk - by Abruzzi    dragster chassis ride height
Go
New
Find
Notify
Tools
Reply
  
dragster chassis ride height
 Login/Join
 
DRR Trophy
Picture of DRACER4883
posted
I recently purchased a 2005 235" Undercover 4-Link dragster, car sets low at rear. Does anyone know what the ride height should be front & rear? I've tried looking up "Undercover Motorsports" to ask them, but I haven't had any luck finding a website or phone number?
 
Posts: 10 | Location: Yukon, Oklahoma | Registered: June 22, 2018Reply With QuoteReport This Post
DRR Pro
posted Hide Post
4 1/2 to 4 3/4 from bottom of bar at mid plate...
 
Posts: 1275 | Location: USA | Registered: December 04, 2008Reply With QuoteReport This Post
DRR S/Pro
Picture of The Bozman
posted Hide Post
quote:
Originally posted by WHOMPWHOMP:
4 1/2 to 4 3/4 from bottom of bar at mid plate...


BINGO !!!!


Keeping the Socialists and NEO-LIBERALS at bay with FACTS one post at a time !!!

Freedom isn't free !!! Thank a veteran, they will actually appreciate it.
 
Posts: 2498 | Location: Gilmer, Texas | Registered: June 25, 2002Reply With QuoteReport This Post
DRR Trophy
Picture of DRACER4883
posted Hide Post
"from bottom of bar" you mean bottom of chassis at mid plate correct? I'll measure it tonight, but I think that will make it have about 1 1/2" of rake down hill from rear to front. Just seems like a lot.
 
Posts: 10 | Location: Yukon, Oklahoma | Registered: June 22, 2018Reply With QuoteReport This Post
DRR Trophy
posted Hide Post
4- 4 1/2 from bottom of mid plate with driver in the car and race ready tire pressure.....Howie
 
Posts: 72 | Location: SYRACUSE,NEW YORK | Registered: October 26, 2005Reply With QuoteReport This Post
DRR S/Pro
Picture of Big Steve
posted Hide Post
Measure from the bottom of the midplate to the ground with you in the car and race ready. 4 1/2 inches.
 
Posts: 2551 | Location: Moving back to the door side | Registered: April 30, 2010Reply With QuoteReport This Post
DRR Trophy
Picture of DRACER4883
posted Hide Post
Thanks for the info everyone! I measured it last night and it was at 3 1/4" inches so I'll get it raised up and see how it works.
 
Posts: 10 | Location: Yukon, Oklahoma | Registered: June 22, 2018Reply With QuoteReport This Post



DRR Trophy
Picture of NC3x58
posted Hide Post
Might want to check your shock spring rate.. Previous owner could have had an aluminum block instead of iron, and if you have iron it could cause the setup to be way off... Just something to consider.


Nick Craig

1971 Camaro Split Bumper
376ci LS3
 
Posts: 410 | Location: Ohio | Registered: December 28, 2013Reply With QuoteReport This Post
  Powered by Social Strata  
 

DragRaceResults.Com    Bracket Talk    Bracket Talk Forum  Hop To Forum Categories  Tech Talk - by Abruzzi    dragster chassis ride height

© DragRaceResults.com 2024