I agree

As I’ve stated, Lippert and their videos are largely useless. They have no info, no videos on my specific slide arms, brackets, motor and controller. Further their generic diagram referencing the arm measurements/angle and brackets also does not work for these slides.

Fortunately, there are several of my specific
MH here at Indy that I’ve been able to get under the slide to take measurements and photos. What I’ve also found is the slide arm brackets are not the same for 2004 and earlier as the 2007 and later which also effects the measurements.

Ed go to truckconversion.net and ask there

I will though at this point is must be voltage related, just doesn’t have enough power to get over the hump, literally.

If you can go straight to the motor with 12 volts and bypass all the circuitry. A good jump box with a on / off switch works well. At least you can see if it is a voltage/amp draw issue.

That’s my next move.