I'm thinking about going to the digital dial board but was curious if you door car guys are getting the single or dual boards? I know it all depends on tower location but seems like I see a lot or cars with them just on the side window vs windshield also. What's been everyone's experience?

We make a very nice clamp on roll bar mount for these if you decide to mount in the rear quarter window.

Get a dual sided dial board, not only do you never have to switch display sides for the tower but in the staging lanes it eliminates confusion over your dial-in.

Of course if you only run Index Classes, save your money, I’m sure they will figure it out.

Bob

If you want to install multiple boards (Door Car) you want the DD V2 controller that works with these.

I only have one dial board and move it from either door window or the rear hatch window.

quote:

Originally posted by RPROGAS:
Get a dual sided dial board...

That would be a waste inside a door car. It isn't like you can mount the board in the center of the car and have it be visible from the tower on either side.

Since I have a Roadster my point of reference is mounting it on the back of the roll cage. Probably not good if it’s mounted inside the car.

Bob