DragRaceResults.Com    Bracket Talk    Bracket Talk Forum  Hop To Forum Categories  Tech Talk - by Abruzzi    Biondo Wiring board and electric shifter
Go
New
Find
Notify
Tools
Reply
  
Biondo Wiring board and electric shifter
 Login/Join
 
DRR Sportsman
posted
Just purchased a car and im having trouble with the shifter shifting on RPM. Its an electric solenoid jegs brand and the yellow wire from the ROM activated switch goes to the RPM prong on the Biondo board, what should the dip switch settings be on the board, im thinking that may not be correct.
 
Posts: 248 | Location: On the top of a bus! | Registered: April 03, 2009Reply With QuoteReport This Post
DRR Pro
posted Hide Post
Move the switch to the GND position.
 
Posts: 2693 | Location: 53056 | Registered: December 30, 2009Reply With QuoteReport This Post
DRR Sportsman
posted Hide Post
When you refer to the “switch” you are referring to the switch on the biondo fuse and relay board right? What about the NO and NC ?
 
Posts: 248 | Location: On the top of a bus! | Registered: April 03, 2009Reply With QuoteReport This Post
DRR Pro
posted Hide Post
I’m making the assumption that this is in fact a Digital Delay fuse/ relay board. Here are the instruction for their present and earlier boards that should apply to yours. If you look at the board, somewhere on the board top face it should say DD vers with date.


The Relay Board also has three slide switches that need to be set. The Output Control Switch is used to control whether the shift output will apply +12 volts (N.O.) to shift or remove +12 Volts (N.C.) to shift. The two Input Selector Switches, one for Time and one for RPM, are used to tell the Elite Relay Board whether +12 Volts or ground is coming from the Shift Controllers. For example, if an Elite 500 is used for the Time Shift Controller the Time Input Selector Switch would be set to +12 Volts to match the +12 volts that the Elite 500 will send out from its shift terminal. Additionally if an MSD RPM Switch is going to be used for the RPM Shift Controller, the RPM Input Selector Switch would be set to ground to match the MSD RPM Switch output.
 
Posts: 2693 | Location: 53056 | Registered: December 30, 2009Reply With QuoteReport This Post
  Powered by Social Strata  
 

DragRaceResults.Com    Bracket Talk    Bracket Talk Forum  Hop To Forum Categories  Tech Talk - by Abruzzi    Biondo Wiring board and electric shifter

© DragRaceResults.com 2024