Bracket Talk
TH 350

This topic can be found at:
https://drr.infopop.cc/eve/forums/a/tpc/f/80760912/m/3247023207

March 05, 2025, 05:42 PM
fastracer482
TH 350
How much “in and out” travel should the shifter shaft have on a TH 350?

The reason for asking is I have a terrible leak at that spot, and while working on it I noticed some movement. I removed the pan and checked the nut on the end of the shaft and it is tight, so I don’t know what else to do.

Thanks for the help Loyd
March 05, 2025, 07:34 PM
Trans Lady
Is the movement in and out or up and down?
March 06, 2025, 09:14 AM
Eman
It has a clip on the shaft that holds it in place. Pull the shift shaft and polish it, I chuck it in a drill and use fine paper. Put a new seal in. If the shaft is smooth a little in and out won't matter if the shaft has a groove or pitting replace it.
March 06, 2025, 11:07 AM
BP758
Room for two seals? Think I remember hearing that .


California Screaming!
Raceless in California!
March 07, 2025, 12:45 AM
fastracer482
[QUOTE]Originally posted by Trans Lady:
Is the movement in and out or up and down?[/QUOTE

It is in and out.
March 08, 2025, 04:28 PM
ohio_dragracer
It is supposed to have clip inside to control in and out movement.
March 08, 2025, 04:33 PM
Trans Lady
quote:
Originally posted by fastracer482:
[QUOTE]Originally posted by Trans Lady:
Is the movement in and out or up and down?[/QUOTE

It is in and out.


The clip that Eman mentioned stops it from moving in and out. Is there one on the shift shaft?

Since you already got the pan down you should just replace the shift shaft and seal.

Sonnax has a kit just for this problem...

https://www.sonnax.com/parts/4...shift-shaft-seal-kit