Ok Pro cube with one timer and using z force. My timer 1 output has voltage going out full time. Programmed for 2.5(left box) and off at 5.
right box
Trying to use to open solenoid for air to shifter. Just setting up to test. What am I setting wrong.

It’s set in normally on mode, switch to normally off.

Right side switch on “config”, middle switch on Tree/Timer 2. Then switch modes by toggling up or down where you would change delay.

Thanks , I found it after little more reading.Hey I am true American male hate reading directions.LMAO

Now if one of these old NOS solenoid is not shorted like 1st one I tried. 1 in 6 and I get shorted out POS 1st thing.