May 28, 2019, 03:20 PM
Mike Friziecsr water pumps
can someone get me in touch with the gentleman who rebuilds these motors? had a question about a special tool or someway to set all the brushes back so I can install it back on the motor? no way to hold all 4 and slide it over the armature!
May 28, 2019, 03:21 PM
Buckygreen1 one here fixed mine.
May 28, 2019, 03:43 PM
Mad DogNot sure how Green does it (he fixed a couple for me also) but I have used a loop of string tied tight around each brush nest. Once you've got the the assembly started over the armature you cut the loops one by one and pull the string out.
PS, leave end of strings long enough to stay outside of the cover to aid in the removal...
Dan
May 28, 2019, 05:10 PM
green1Mike there are two different motors that are used. If you have one with flat brush plate then you push them all the way back in until they stick in place then pop them out with small Allen wrench or such through back of the brush holder after almost fully assembled. The other type I use single strand of wire through the small hole in brush holder to hold them in place till assembled then pull out, some people use paper clips.