Have any of you had any experience with the Summit or Jegs SFI Flexplates? I need to get a new one for my 582 BBC and was just shopping around.
I’ve been using the TCI flex plate with no issues on our stuff. About $80.
Love the Mezeiere billet wheel in my Sunset 565
62 Bel-Air 409
79 Cole TR-2 SunsetRaceCraft 565 RIP TRACY
260 Eliminator Eagle XP HP500EFI
NO MO BOMA
WELL DONE USN SEAL TEAM 6
Got a part number?
TCI-399273 (Internal/168) is what i use. Just recheck to be sure.
Make sure you put a small taper on the flange bolt holes when using ARP bolts. The have a tiny taper on the underside of the bolt. So the head sits flush on the plate. JMO.This message has been edited. Last edited by: TD3550,
Meziere in mine, broke the TCI at Tucson last year.
I like ATI myself.
Green1 what ATI plate you using, I see they have two ??
Unless you have money to waste or have a 582 on Nitrous/Blower/Turbo turning 1500 horses or more I wouldn't waste my money on the higher end Mezeiere Billet ones. Its over kill and yea you can say never look back UNTIL you break one, as happened to me (it does happen). If you run NHRA you only get 3 years out of one any way technically. We ran a TCI and BTE one for over 3 years each without any problems. Nor any transmission problems related to the extreme flexing some say will happen.
|DRR Top Comp|
Don’t buy the chinese knock off of the Meziere billet one. A guy I know bought one and it sure looked great till most of the teeth broke off.
Clowns to the left of me, Jokers to the right. Here I am.......
"Just Shut Up and Race"
139 tooth JW or ATI
You would have to change the starter drive too but you have a far stronger setup and even if your engine kicks back, you won’t break a tooth off the flex plate.
I had a JW and had it re-certified once. It expired again so it was 6 years old and I just put an ATI on a fresh engine.
It’s a much larger tooth design and way stronger.
The cheap flex plates no matter who’s name is on them are probably offshore made. Not very good quality.
Couple guys already said it, one piece billet flexplate from Meziere
ATI 915541 for internal balanced
So even the $400 meziere need to be recerted every 3 years correct? I ran csr for probably too long. If they get changed out every 3 years i dont get buying an expensive one but i guess to each their own.
2014 Byron Overall Track Champion
Byron's actual elevation is 730' because that matters more than winning anything ever....
^^^^^^^^ THIS, $90 3 year throw away. Half the price of the cheapest Drivers Latch Link Belts you could buy that are only good 2 years and never wear out.
I wire brush the paint off crank mounting side and deburr bolt holes. The convertor mounting bolt holes need to be enlarged if using 7/16” bolts per the instructions.
Just wondering when was the last time someone had an NHRA tech crawl under your car to check the date on your flexplate?
I've never seen it but I did have a converter bolt pad break off one that was either 10 years old or 10 years expired.
I agree with those saying just buy the cheapies and replace every 3 years.
Sorry, no Bend pac lifts here. lol
But i can tell you this. After qualifying all the racks after we were done were not allowed to return to our pits. The gathered all of us on the return road in single file. Had to pull all the body panels off. Looking for illegal boxes/devices.. I said WTF, we having a convention? AND yes they did get one.
|Powered by Social Strata||Page 1 2 3|