Looking if anyone has any pictures or products of a very clean access panel installed. Specifically on a roadster but looking for something clean. Car is going from a .90 car on gas to a bracket car on alch and taking off 10 dzus fasteners and a hood in late rounds is not convienient.
I ended up using parts of this to install the fuel door on my hood. I cut the fiberglass and reused the portion I cut out. It takes a steady hand or in my case, a lot of filing to get the lines straight again. I used the thinnest cut off wheel I could find for the straight lines and a coping saw blade by hand for the radius corners.
Take your time to measure and prep everything. The more time you take, the better it will look when completed.
I did the same thing as above on my old camaro. Take your time and reuse the chunk you cut out. A rotozip with a small bit works good also. just use the hardware from the kit.
Posts: 337 | Location: up on the wheel | Registered: March 06, 2001
