Once you start the “Time From Launch Timer” by cycling the Launch wire (even with the engine not running and ignition ON) the timer will run to 30 seconds and stop.
There are 2 ways to reset it. If you turn OFF the ignition and turn back ON it is set to 0.00. If the engine is running (and even if not) and the TFLT is timed out, re-cycling the Launch input (push and release the TB button) will reset TFLT to 0.00 but it will start running again. Depending on how long the Safety Run-Time is set to you probably have enough time to do the BO after it starts again.
To view this in Grid real time, turn on ignition (engine not running) in Gauge 1 tab select Time From Launch and cycle the Launch input.
Do you use a delay box, and if so with SLE enabled?
Good to know Mark.
Yes I run an SLE..
"It is usually futile to try to talk facts and analysis to people who are enjoying a sense of moral superiority in their ignorance." -Thomas Sowell
Any one experienced the 7720 having a “weak” spark under a load that might poor performance?
2011 Diamond Chassis Dragster
|Powered by Social Strata||Page 1 2|