DragRaceResults.Com    Bracket Talk    Bracket Talk Forum  Hop To Forum Categories  Tech Talk - by Abruzzi    Tire slippage = poor reaction time?
Go
New
Find
Notify
Tools
Reply
  
Tire slippage = poor reaction time?
 Login/Join
 
DRR Trophy
Picture of Bad Nusz
posted
Guys, do you commonly find that if your tires spin, or rather slip a little at the starting line and not 'dead hook', that your reaction time is a little longer?

When I raced last Sunday, throughout time trials and in the first round of competition my drag truck ran pretty consistently, varying by only a few thousandths from pass to pass. My reaction times were .05 to .08; unremarkable.

But I lost in the second round when my truck ran nearly 3 hundreths of a second off-dial and my 60' was off by about .02 second.
My reaction time was .120. Though my opponent cut a .130 light, I was too far off dial to win.

I could have sworn that I left the starting line at the same point on the tree. I initially blamed my loss on my sleeping at the tree.
Perhaps I can somewhat blame it on tire spin. Wink

My weather station didn't seem to indicate a change in the atmosphere.

Could I have lost that much at the tree with a little spin?

I did look through the archives on this forum to see if my question has already been covered.

Thanks!
Troy
 
Posts: 338 | Location: Sioux Falls, SD | Registered: March 17, 2018Reply With QuoteReport This Post
DRR S/Pro
posted Hide Post
If I had to guess here I'd say 99% of it was you and 1% tire spin that caused that late of a light. Forget it and move on.
 
Posts: 2156 | Location: Tewksbury, MA,USA | Registered: November 03, 2000Reply With QuoteReport This Post
DRR Sportsman
Picture of FootbrakeJim
posted Hide Post
Are you foot-braking, or T-Brake/Box?
I would say Top38 is probably right, (although maybe I would go 95%-5%) Big Grin
Lot of potential causes. Sometimes you don't want to over-think things.
As a friend of mine likes to say: Flush, wipe, and go on. Wink


Dan "Jim" Moore
Much too young to feel this damn old!!
 
Posts: 1037 | Location: Farmersville, TX  | Registered: December 05, 2002Reply With QuoteReport This Post
DRR Sportsman
Picture of TD3550
posted Hide Post
As you well know, concentration is 100% of the rule. But never over think it. Never heard of a driver that nerves don't come into play. Drive your own race. This takes years as you know. An example, Friend of mine put together a new motor for his rack. First couple times out he has too much going on in the ****pit.Thinks he is getting it done 7.40 car. I knew he was not in the right frame of mind.Well lets put a camera on the back i tell him. Looking at the throttle response when your on the 2 step. Watching that throttle cable go back and forth ever so slightly. Now looking at the throttle cable response on his voyage to the 1320 was eye opening. See, what did i tell you, your 2 stepping it. He never believed it until he watched the video facing the carbs. Race your own race and don't beat your self at your own race.Troy you will be fine. Give it time.

I see too many times where one is worried about the other lane. Don't.....

This message has been edited. Last edited by: TD3550,
 
Posts: 1409 | Location: Under a Truck | Registered: August 23, 2013Reply With QuoteReport This Post
DRR Sportsman
posted Hide Post
The question was about tire slippage at launch affecting r/t.
Seems to me if car is stationary while tire spins, of course it's going to affect reaction time by same amount of time it takes car to trip lights after initial spin starts and car doesn't move.
O.P. says 60' off by .02 and r/t and et off by similar amount. Yes, I'd be suspicious.
 
Posts: 606 | Location: Lakewood, Co. | Registered: January 22, 2007Reply With QuoteReport This Post
DRR Pro
Picture of Eman
posted Hide Post
The answer is yes it could.
 
Posts: 1461 | Location: E TN | Registered: February 13, 2009Reply With QuoteReport This Post
DRR Trophy
Picture of Bad Nusz
posted Hide Post
Thanks, guys; all helpful answers.
 
Posts: 338 | Location: Sioux Falls, SD | Registered: March 17, 2018Reply With QuoteReport This Post



DRR Pro
Picture of Eman
posted Hide Post
My local track has very questionable track prep. There are times when many struggle to hook and it does effect the RT but you can generally feel it in the car when you leave. My car will vibrate a little with slicks, it will rattle like a funnycar on radials if it spins. Are you feeling anything?
 
Posts: 1461 | Location: E TN | Registered: February 13, 2009Reply With QuoteReport This Post
DRR Trophy
Picture of Bad Nusz
posted Hide Post
Thanks, Eman.
My own track usually has pretty good prep.
You know, I can't say that I feel anything unusual, but perhaps I'm not sensitive enough?

But I reckon that my tires only need to slip just a little bit to slow me down by .03 second or so in the quarter mile.

FWIW, I 'think' I can usually tell if I hit the tree right or not.

Lol, I wish I were some sort of electronics guru and could invent a gadget that could compare the track surface speed to the tire speed, to detect and report slippage. ;^)
 
Posts: 338 | Location: Sioux Falls, SD | Registered: March 17, 2018Reply With QuoteReport This Post
DRR Trophy
Picture of Dead On
posted Hide Post
There is its called a data logger, you can see tire slippage there in the form of drive shaft RPM. I was told you can even see it in the shock travel if you monitor that also. They are expensive, but as one racer puts it if you don't have data your just another racer with an opinion.
 
Posts: 73 | Location: Texas | Registered: March 18, 2015Reply With QuoteReport This Post
DRR Trophy
Picture of Dead On
posted Hide Post
https://drr.infopop.cc/eve/foru...55-DC3BC3B84E39.jpeg
If it works here is an example of tire slippage on a data logger where as this is tire chatter/shake you can still see the difference in drive shaft RPM going up and down. In you case it would go up a short time then down and start a smooth upward climb until the shift then down and slowly back up again.
 
Posts: 73 | Location: Texas | Registered: March 18, 2015Reply With QuoteReport This Post
DRR Trophy
Picture of Bad Nusz
posted Hide Post
Thank you, Ron.
I suppose I should think about investing in a data logger. Maybe get to the money rounds more often, heheh.

I have to wonder how it detects slippage via driveshaft RPM; would it not need something like ground speed to compare that to?

Anyway, another feature of the data logger I've heard of too is that it can report your rear tire temp. I'm trying however to figure out a way of giving me a direct reading of tire temp via some gauge on my dash.
 
Posts: 338 | Location: Sioux Falls, SD | Registered: March 17, 2018Reply With QuoteReport This Post
DRR S/Pro
posted Hide Post
Slippage is detected but the sudden change in driveshaft rpms. All it does is show driveshaft rpms which on a normal run is a slow climb, not a spike on the graph.
 
Posts: 2591 | Location: at the track | Registered: May 09, 2007Reply With QuoteReport This Post
DRR Pro
Picture of CURTIS REED
posted Hide Post
Here is an illustration of tire slippage on a loose track versus no slip. I only have the driveshaft speed turned on in this pic. Now, the loose pass is low gear leave and the other is high gear only though.




____________________________
2017 and 2018 Osage Casinos Tulsa Raceway Park No-Box Champion

2018 Div4 Goodguys Hammer award winner
 
Posts: 2944 | Location: KIEFER, OK. | Registered: August 17, 2007Reply With QuoteReport This Post



DRR S/Pro
Picture of Big Steve
posted Hide Post
quote:
Originally posted by CURTIS REED:
Here is an illustration of tire slippage on a loose track versus no slip. I only have the driveshaft speed turned on in this pic. Now, the loose pass is low gear leave and the other is high gear only though.



Curtis that looks like a dirt road not a loose track.....geez
 
Posts: 2427 | Location: Moving back to the door side | Registered: April 30, 2010Reply With QuoteReport This Post
DRR Trophy
Picture of DaleH
posted Hide Post
On this graph I assume the x-axis is time. I cant quite make out the scale but say reaction time is changing from .015 to .035 or higher can you see that small on the scale provided to determine tire slippage? How many magnets on the DS collar? Some simple math with tire roll out and rear gear should determine how precise the measurement would be.

Just curious as I haven't invested in a logger yet either.

Dale



quote:
Originally posted by CURTIS REED:
Here is an illustration of tire slippage on a loose track versus no slip. I only have the driveshaft speed turned on in this pic. Now, the loose pass is low gear leave and the other is high gear only though.

 
Posts: 61 | Location: MN | Registered: August 02, 2005Reply With QuoteReport This Post
DRR Pro
Picture of CURTIS REED
posted Hide Post
No you aren't going to see that about your reaction times. My collar has 4 magnets.

Let's see if I can make this larger.




____________________________
2017 and 2018 Osage Casinos Tulsa Raceway Park No-Box Champion

2018 Div4 Goodguys Hammer award winner
 
Posts: 2944 | Location: KIEFER, OK. | Registered: August 17, 2007Reply With QuoteReport This Post
DRR Pro
Picture of CURTIS REED
posted Hide Post
quote:
Originally posted by Big Steve:


Curtis that looks like a dirt road not a loose track.....geez


That’s just roadster life. Laughing Hard



____________________________
2017 and 2018 Osage Casinos Tulsa Raceway Park No-Box Champion

2018 Div4 Goodguys Hammer award winner
 
Posts: 2944 | Location: KIEFER, OK. | Registered: August 17, 2007Reply With QuoteReport This Post
  Powered by Social Strata  
 

DragRaceResults.Com    Bracket Talk    Bracket Talk Forum  Hop To Forum Categories  Tech Talk - by Abruzzi    Tire slippage = poor reaction time?

© DragRaceResults.com 2024