March 15, 2020, 11:15 AM
SmokinChickenJesel Sportman Rockers
Picked up a set of Brodix Bb2 heads and some Jesel Sportsman Rockers. Completely un assembled. There is a washer that I assume goes under one of the rockers/stand but does it go on the exhaust or intake side? Anyone know.
March 15, 2020, 11:20 AM
SCDIV1I've used them and there was no washers of any kind under either stand.
Just the alignment plates to keep the stands aligned to the valves.
The stands bolt directly to the head.
Brodix 3x heads.....
March 15, 2020, 11:57 AM
SmokinChickenWell these have a washer set up, 4 for each side
March 15, 2020, 01:15 PM
183NLook at the bottom of the stands and see if you can see evidence of which ones had a washer.
You’ll probably have to read the directions on how to set the stand height to achieve proper rocker geometry, that’s why the washer is there. T&Ds come with a tool, not sure about those.
March 15, 2020, 01:49 PM
chasracercontact Jesel and go from there.
March 15, 2020, 07:17 PM
Bad NewsMissing some washers, the washers are used to set the geometry, IE stand height.
March 15, 2020, 09:06 PM
Ron C.Was gonna say,...the washers are used for minor adjustments to rocker geometry .
March 16, 2020, 12:44 PM
SCDIV1Jesel used to supply a plastic part to check stand height and rocker geometry....
The shims or washers would be used as was mentioned to raise the stand if necessary.
I don't recall the sportsman shaft rocker set coming with those pieces but I assume they do.
A call to Jesel would net you the correct answers and they do have setup and install instructions with pictures on their website.
March 20, 2020, 06:31 PM
23talteredMy Jesel Sportsman rockers for AFR heads came with shims for one side, but I can't remember which. It is easy enough to mock them up and check geometry.
April 04, 2020, 09:42 PM
1320racerRan them many years ago, would not recommend them, cheap alternative to full shaft rockers.