DragRaceResults.Com    Bracket Talk    Bracket Talk Forum  Hop To Forum Categories  Tech Talk - by Abruzzi    dodge techs? Stalling 2005 ram 5.7
Go
New
Find
Notify
Tools
Reply
  
dodge techs? Stalling 2005 ram 5.7
 Login/Join
 
DRR Top Comp
Picture of wideopen231
posted
Ok to keep short
My 2005 dodge ram 1500 crewcab with 5.7 has had a stalling occasionally deal for while. Yesterday it died going down road. Would fire and die,dozen times. Got it home now will fire and idle with.Have to be handy with starting fluid to keep idling. Checked pressure at rail. 40 lbs during prime, zero or close when idling.

My guess is fuel pump. Just like to see if other opions before dropping the full(of coarse) tank.On l;ift its not big deal on ground its huge pain in a$$. Hate to swap pumps and find something stupid simple later.

Ideas?




America home of free. Brought to you by 2nd amendment.
 
Posts: 4178 | Location: Greensboro NC | Registered: May 24, 2011Reply With QuoteReport This Post
DRR Sportsman
Picture of sr4440
posted Hide Post
A few questions

Did you check fuel pressure before or after the fuel filter?

did you check the fuse and relay for power?


Joe


Without data, you’re just another guy with an opinion.
 
Posts: 1297 | Location: TEXAS | Registered: February 07, 2003Reply With QuoteReport This Post
DRR S/Pro
Picture of "The Bender"
posted Hide Post
Fuel pressure spec is 58#, should be that at idle.

If you drop the tank be very careful when disconnecting the lines, the nipples on the tank are plastic and break very easily. If you break the vapor nipple it is part of the tank and you have to replace the tank and it is VERY expensive. We just fixed one for a customer that replaced his own pump.

You can also unbolt the bed and raise the front of the bed for access, pick your poison.....

DO NOT put a cheap pump in it, go for a Carter or Delphi or an OEM pump.


272" Spitzer
540 Chevy
The Blower Shop XR1
FTI XPM Series Converter
FTI Level 6 Powerglide
3.69@199
.916 60'

2017 Bradenton Heads Up Madness
Open Outlaw Champ

2018 PDRA T/D #5
2019 PDRA T/D #2

2020 Retired From T/D Competition....

2020 Bradenton NMCA Hemi Shootout Winner

2021 getting back into bracket racing with a Gen3 Hemi powered 87 Cutlass.
 
Posts: 3096 | Location: Yes | Registered: July 08, 2009Reply With QuoteReport This Post
DRR Top Comp
Picture of wideopen231
posted Hide Post
seems no filter other than in tank. Non listed anywhere. Filter weas my thought since I have never had pump go bad and not just quit.




America home of free. Brought to you by 2nd amendment.
 
Posts: 4178 | Location: Greensboro NC | Registered: May 24, 2011Reply With QuoteReport This Post
DRR S/Pro
posted Hide Post
Is there a return pressure regulator on the system?


Illegitimi non carborundum
 
Posts: 2331 | Location: OKC, OK | Registered: February 15, 2008Reply With QuoteReport This Post
DRR S/Pro
Picture of "The Bender"
posted Hide Post
The only filter is the "sock' on the pump.

I have seen them just quit, then start working again...….


272" Spitzer
540 Chevy
The Blower Shop XR1
FTI XPM Series Converter
FTI Level 6 Powerglide
3.69@199
.916 60'

2017 Bradenton Heads Up Madness
Open Outlaw Champ

2018 PDRA T/D #5
2019 PDRA T/D #2

2020 Retired From T/D Competition....

2020 Bradenton NMCA Hemi Shootout Winner

2021 getting back into bracket racing with a Gen3 Hemi powered 87 Cutlass.
 
Posts: 3096 | Location: Yes | Registered: July 08, 2009Reply With QuoteReport This Post
DRR Sportsman
Picture of sr4440
posted Hide Post
quote:
Originally posted by "The Bender":
The only filter is the "sock' on the pump.

I have seen them just quit, then start working again...….


didn't know that (don't own a gas powered truck), kinda stupid.

Pull the bed, easier then draining the tank.

Joe


Without data, you’re just another guy with an opinion.
 
Posts: 1297 | Location: TEXAS | Registered: February 07, 2003Reply With QuoteReport This Post



DRR S/Pro
Picture of "The Bender"
posted Hide Post
I can't think of a newer car or truck that uses a replaceable fuel filter anymore...... Roll Eyes


272" Spitzer
540 Chevy
The Blower Shop XR1
FTI XPM Series Converter
FTI Level 6 Powerglide
3.69@199
.916 60'

2017 Bradenton Heads Up Madness
Open Outlaw Champ

2018 PDRA T/D #5
2019 PDRA T/D #2

2020 Retired From T/D Competition....

2020 Bradenton NMCA Hemi Shootout Winner

2021 getting back into bracket racing with a Gen3 Hemi powered 87 Cutlass.
 
Posts: 3096 | Location: Yes | Registered: July 08, 2009Reply With QuoteReport This Post
DRR Sportsman
Picture of sr4440
posted Hide Post
My last new car was a 2001. LOL


Joe


Without data, you’re just another guy with an opinion.
 
Posts: 1297 | Location: TEXAS | Registered: February 07, 2003Reply With QuoteReport This Post
DRR Top Comp
Picture of wideopen231
posted Hide Post
pump fixed it. While I did read post about not breaking plastic crap,i did it anyway. Nothing a bunch of epoxy didn't fix.Will be ***** getting line off next time,we;; unless damn thing just catches fire.LOL




America home of free. Brought to you by 2nd amendment.
 
Posts: 4178 | Location: Greensboro NC | Registered: May 24, 2011Reply With QuoteReport This Post
DRR S/Pro
Picture of "The Bender"
posted Hide Post
Hate to say I told you so, but I told you so!


272" Spitzer
540 Chevy
The Blower Shop XR1
FTI XPM Series Converter
FTI Level 6 Powerglide
3.69@199
.916 60'

2017 Bradenton Heads Up Madness
Open Outlaw Champ

2018 PDRA T/D #5
2019 PDRA T/D #2

2020 Retired From T/D Competition....

2020 Bradenton NMCA Hemi Shootout Winner

2021 getting back into bracket racing with a Gen3 Hemi powered 87 Cutlass.
 
Posts: 3096 | Location: Yes | Registered: July 08, 2009Reply With QuoteReport This Post
DRR Top Comp
Picture of wideopen231
posted Hide Post
Don't seem you ahte it that much.LMAO now.




America home of free. Brought to you by 2nd amendment.
 
Posts: 4178 | Location: Greensboro NC | Registered: May 24, 2011Reply With QuoteReport This Post
DRR S/Pro
Picture of "The Bender"
posted Hide Post
You're right!

I told you so.....


272" Spitzer
540 Chevy
The Blower Shop XR1
FTI XPM Series Converter
FTI Level 6 Powerglide
3.69@199
.916 60'

2017 Bradenton Heads Up Madness
Open Outlaw Champ

2018 PDRA T/D #5
2019 PDRA T/D #2

2020 Retired From T/D Competition....

2020 Bradenton NMCA Hemi Shootout Winner

2021 getting back into bracket racing with a Gen3 Hemi powered 87 Cutlass.
 
Posts: 3096 | Location: Yes | Registered: July 08, 2009Reply With QuoteReport This Post
DRR S/Pro
Picture of Big Steve
posted Hide Post
And since you fixed it with epoxy that fire you spoke of may be in your future...
 
Posts: 2410 | Location: Moving back to the door side | Registered: April 30, 2010Reply With QuoteReport This Post



  Powered by Social Strata  
 

DragRaceResults.Com    Bracket Talk    Bracket Talk Forum  Hop To Forum Categories  Tech Talk - by Abruzzi    dodge techs? Stalling 2005 ram 5.7

© DragRaceResults.com 2024